Eagtac D3C Ti 800 Lumen Pocket Torch – 128 Metres

Description

• 800 LED lumen powered by CREE XM-L2 U4 LED
• Two group outputs; Four brightness levels and seven hidden AUX modes
• Programmable settings; Mode memory
• Turbo boost technology
• Reversed clicky on/off tailcap switch
• Uses protected 1x CR123A/RCR123A li-ion battery (not included)
• 140 yards / 128 metres maximum beam distance
• Up to 1 hrs on MAX output, 300 hrs on low output

CREE XM-L2 LED

LED Lumen: 800*~410 / 155 / 55-35-21 / 16-2-0.5

ANSI Lumen: 560*~310 / 120 / 40-26-17 / 13-2-0.5

Center LUX: 4,100

Runtimes: 0.6-1 – 300 hours 

Dimensions: 

Length: 2.9 inch (7.5 cm)

Body Diameter: 0.78 inch (2 cm)

Head Diameter: 0.78 inch (2 cm)

Body Weight (excluding batteries): 1.4 ounce (40 grams)

*At maximum output level (100%), the active thermal management feature slowly reduce the maximum output level according to the flashlight internal temperature to 50% once flashlight reaches 140°F (60 °C) (higher surrounding temperature may result in higher flashlight temperature). It’s normal for high power flashlight to run hot at MAX level. Reduce the output if the user finds the flashlight too warm to hold.

*Output is same regardless of battery type used. Active cooling (blowing cool air toward the light) or passive cooling (holding the light in your hand) helps preventing excessive heat built at the LED. Turn off the light to allow it to cool down if you find the flashlight too hot to hold. Do not leave the light running unintended with li-ion.  

What’s included:

• Spare o-rings
• User Manual
• Rigid Nylon Holster w/ self-retention device and flip
• Mil-Spec Paracord Lanyard w/ quick attachment clip

Operation:

Basic – Press on the switch button until it clicks to turn on the flashlight. Press the switch again until it clicks to switch off the light.

Access output groups 1 & 2 – Tighten the head to access group 2 output. Loosen the head to access group 1 output.

Group 1: MAX – Strobe (Variable) – cycle

Group 2: Very low – low – med – high – Very low – low – med – high – Strobe(Constant)- Flash(Hi)- S.O.S.(Fast) – Beacon – Flash(Low) – cycle

Switch between output level – With the flashlight on, slightly press the switch and release (within 1s) to switch to the next output.

Switch between output level – With the flashlight on, slightly press the switch and release (within 1s) to switch to the next output.