- Water white glass lens w/ harden treatment
- Anti-reflective (AR) coating on both side (96% transparency)
- Synchronous buck w/ efficiency of up to 95%
- Non-dimming constant current regulation for all output levels without flicking
- Low battery voltage warning
- Turbo boost output (user adjustable to prolong runtime)
- Very low standby current (uA)
- Smooth aluminium reflector
- HAIII hard anodization aerospace aluminium
- IPX-8 standard
CREE XM-L2 U2 LED
Center lux: 39,300 lux
Center spot angle: 6°
Spill light angle: 57°
Beam distance: 433 yards / 396 meters
Maximum output of up to 1305 LED or 1049 ANSI lumens
Runs off 6 x AA batteries
Head diameter: 47mm
Tube diameter: 36mm
Weight: 260g (without battery)
1 x Lanyard
1 x Spare o-rings
1 x Instructions
1 x Warranty Card
Easy on/off operation
Turn on the light by press and release the on/off button switch (<0.4s). To turn off the light, press and release the switch again.
Press and hold the button switch for immediate output. Release the switch to turn off the light.
Twist the head to select between four output brightness levels. You can pre-select the desired output level before turning on the flashlight.
Instant 100% output
At any output level, press and hold the flashlight for 100% output. Release the button to return to previous level.
Instant strobe output
At any output level, double press and hold the on/off button switch for strobe output. Release the button to return to previous level. This also work when the flashlight is off.
Access hidden auxiliary mode
With the head at tight position (1st level), loosen to 3rd (or 4th level) and tighten the head within one second to enter AUX. setting. Repeat to cycle through all settings. Turn off the light or loosen the head to quit.
To switch between tactical mode (default) and regular mode, turn on the flashlight at 1st level, dial to 2nd level and then back to 1st level for five times within five seconds.
Turbo boost technology
This is activated every time you turn on at turbo output setting. It offers 25% more power to the LED for the first 200 seconds at turbo mode. It’s normal for the light to get warm at such level. Do not leave the light running unintended.